Connecting The Speakers; Connecting External Equipment - JVC FS-MD9000J Instructions Manual

CAUTION: Make all connections before plugging the System into an AC power outlet.

Connecting the Speakers

1. Open each of the terminals to connect the speaker wire leads.
2. Connect the speaker cords between the Speaker terminals of the Unit and the terminals of the Speakers.
Connect the cords with a black line to the (–) terminals and cords without a black line to the (+) terminals.
3. Close each of the terminals to securely connect the cords.
CAUTION: A TV may display irregular colors if located near the speakers. If this happens, set the speak-
ers away from the TV.
Removing the speaker grilles
The speaker grilles can be removed.
When removing,
1. Insert your fingers at the top and pull towards you.
2. Also pull the bottom towards you.

Connecting External Equipment

Connecting a Tape Deck, etc.
Connect (not supplied) signal cords between the System's LINE IN (AUX1)/OUT terminals and the output/input terminals of the external tape
deck, etc.
You can listen to one of these sources. Also, you can record the System's CD Player, MD Player, or tuner output signal to the external tape deck,
etc..
R L
4
Right speaker (rear side)
Marked with a black line
SPEAKERS
IMPEDANCE
MIN 4
L
R
SPEAKER CORD
Speaker cord
Signal cord (not supplied)
Pin-plug x 2
LINE IN
(AUX1)
LINE OUT
Signal cord (Not supplied)
Pin-plug x 2
Left speaker (rear side)
Attaching the speaker grille
Tape deck, etc. (not supplied)
Pin-plug x 2
Pin-plug x 2
Speaker grille