Table of Contents
Advertisement
CANSwitch-AF2S2
High-Performance Dual-CAN to Fiber Switch User Manual
4. Quick Use in Converter Mode (Converter Mode)
4.1 Device Configuration Method
Turn the switch to Converter, and press the reset button to enter Converter mode.
The device will beep twice if the configuration is successful.
CANSwitch-AF2S2 supports using the serial port to configure the device, as shown in
Figure 4.1. The device can be configured as long as the dedicated RS232 configuration
port is connected to the PC.
4.2 IP Address Operation
4.2.1 Default Settings of the Device IP Address
The default IP address of the CANSwitch-AF2S2 high-performance dual-channel
CAN-to-fiber switch device is 192.168.0.178.
4.2.2 Obtaining the Device IP Address
When you forget the IP address of the device or the device uses the DHCP protocol
to obtain the IP address automatically, the current IP address of the device can be
obtained by using the ZNetCom software. The CANSwitch-AF2S2 device supports two IP
address acquisition methods: "static acquisition" and "dynamic acquisition". "Static
acquisition" indicates that the device uses the "IP address", "subnet mask" and "gateway"
specified by the user; "Dynamic acquisition" indicates that the device obtains the IP
address, subnet mask, and gateway information from the DHCP server on the network
over DHCP.
The ZNetCom software is the configuration software of CANSwitch-AF2S2 device
running on Windows. No matter what the current IP address of the CANSwitch-AF2S2
device is, you can obtain the current IP address of the CANSwitch-AF2S2 device by using
ZNetCom software and configure it. The procedure for obtaining CANSwitch-AF2S2
device IP address using ZnetCom software is as follows:
1.
Connect the hardware. Connect the device to the 9-36 V DC power supply. It can
be connected to the PC by optical fiber and serial port (RS232).
2.
Install ZNetCom (version 2.95 or later). For the installation method of ZNetCom
software, see 5.1 Installation and Configuration Software.
3.
Double-click to run the ZNetCom software (if the system is later than Windows 7,
right-click it and run as administrator). The interface shown in Figure 4.2
Figure 4.1 Dedicated configuration port
©2021 Guangzhou ZLG Electronics Technology Co.,Ltd.
20
User Manual
Advertisement
Table of Contents
