Table of Contents
Advertisement
CANSwitch-AN2S2
High-Performance Dual-CAN to Ethernet Switch User Manual
4. Quick Use in Converter Mode (Converter Mode)
4.1 Device Configuration Method
Turn the switch to Converter, and press the reset button to enter Converter mode.
The device will beep twice if the configuration is successful.
4.1.1 Configuring the Device over the Serial Port
CANSwitch-AN2S2 supports using the serial port to configure the device, as shown in
Figure 4.1. The device can be configured as long as the dedicated RS232 configuration
port is connected to the PC.
4.1.2 Configuring the Device over the network port
CANSwitch-AN2S2 supports configuration using the LAN port. As shown in Figure
4.2, just connect one of the network ports to the PC.
4.2 IP Address Operation
4.2.1 Default IP Address
The default IP address of CANSwitch-AN2S2 high-performance dual-channel CAN to
Ethernet switch device is: 192.168.0.178.
4.2.2 Obtaining the Device IP address
When you forget the IP address of the device or the device uses the DHCP protocol
to obtain the IP address automatically, the current IP address of the device can be
obtained by using the ZNetCom software. The CANSwitch-AN2S2 device supports two IP
address acquisition methods: "static acquisition" and "dynamic acquisition". "Static
acquisition" indicates that the device uses the "IP address", "subnet mask" and "gateway"
specified by the user; "Dynamic acquisition" indicates that the device obtains the IP
address, subnet mask, and gateway information from the DHCP server on the network
over DHCP.
Figure 4.1 Dedicated configuration port
Figure 4.2 LAN port
©2021 Guangzhou ZLG Microelectronics Technology Corp.,Ltd.
20
User Manual
Advertisement
Table of Contents
