BMC G2S BPAP Series Quick Operation Manual
Hide thumbs Also See for G2S BPAP Series:

Advertisement

G2S BPAP Series Quick Operation Manual

1. Button Functions

Ramp Button: Press it to enable the Ramp feature
Mute Button: Press it to mute the alarms
Knob: Start treatment and adjust device settings

2. Setting up the Device

Power Cord
Power Outlet
E
A. Connect one end of the tube to the assembled mask.
B. Connect the other end of the tube securely to the air outlet of the device, as shown in the figure
above.
C. Connect the power adapter to the DC inlet of the main device.
D. Connect the power cord to the power adapter.
E. Plug the power cord into the power outlet.

3. Adjusting Device Settings

A. After the device is connected to power, its screen displays the Main Interface shown in the first
figure below, or the Main Interface shown in the second figure
in the third figure below, or the Main Interface shown in the fourth figure below.
Note: The value of blood oxygen saturation (SpO
connected to the main device
The
above
interface
The
only applies to G2S
only applies to G2S
B20S, G2S B20A.
B20T.
G2S BPAP Series Quick Operation Manual V2.0
A
Mask
Tube
Power Adapter
D
) and pulse rate can only be seen after the SpO
2
correctly.
above
interface
The above interface only
applies to G2S B25A,
G2S B25S.
1 / 2
B
Air Outlet
C
Device
DC Inlet
below, or the Main Interface shown
The above interface only
applies to G2S B25T, G2S
B25VT, G2S B30T, G2S
B30VT, G2S B30AT and
G2S LAB.
Filter Cap (Air Inlet)
Kit is
2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the G2S BPAP Series and is the answer not in the manual?

Questions and answers

Summary of Contents for BMC G2S BPAP Series

  • Page 1 G2S BPAP Series Quick Operation Manual V2.0 G2S BPAP Series Quick Operation Manual 1. Button Functions Ramp Button: Press it to enable the Ramp feature Mute Button: Press it to mute the alarms Knob: Start treatment and adjust device settings 2.
  • Page 2 G2S BPAP Series Quick Operation Manual V2.0 B. From the Main Interface shown above, press and hold the Ramp Button for three seconds. The screen displays the Initial Setup Interface, as shown in the figure below. C. Press the Knob to access the Setup Interface, as shown in the figure below.

Table of Contents