Oil Specifications For Drop Gearbox - SAC TURBO-MAX 6141 Operator's & Parts Manual

APPENDIX

OIL SPECIFICATIONS FOR DROP GEARBOX

OIL CHANGE: After initial 100 hours, then every 1000 hours or annually thereafter. These
intervals may be modifi ed depending on the actual operating conditions. If used on seasonal
equipment, it is recommended that the oil be changed at the end of each season to remove
moisture and corrosive contaminants.
OIL FILL LEVEL: Unit should be fi lled so that the oil is to the top of the fi ller neck or to the
middle of the sight guage. (if so equipped)
OIL TYPE: EP 80 to 90 WT gear lube, Viscosity Index of 93 and a viscosity of 780 @ 100 degrees
F SUS and 76.7 @ 210 degrees F SUS is recommended.
GEARBOX TEMPERATURE: DO NOT EXCEED 200 DEGREES F.
OIL SPECIFICATIONS FOR ELECTRIC HYDRAULIC UNIT
OIL CHANGE: Normal change intervals of 1000 hours or annually should be followed. Oil
should be changed with the hydraulic cylinders retracted.
OIL FILL LEVEL: With the hydraulic cylinders retracted, fi ll the reservior to 1-1/2" below the
fi ller cap.
OIL TYPE: Dextron III Automatic Transmission Fluid
OIL TEMPERATURE: DO NOT EXCEED 200 DEGREES F.
Page # 48