Austravel Emergency Screen; Setting Emergency Call Parameters; Testing Emergency Settings - Codan Envoy Manual

There is no easy way to test these settings without setting off Emergency Alarms all over Australia.
You can work your way back into the Emergency Settings to make sure the last channel setting is set to SEND
POSITION.
This setting will allow the Envoy to return to SCAN MODE automatically after the Emergency Call chain is com-
plete.
This document and graphics courtesy of Colin Ingham 6355 on behalf of the Austravel Safety Net HF Radio
Network are intended for the owners/operators of Codan Envoy's X1/X2 that are part of the Austravel Safety
Net Group. Please check you radio for the setting above.
This document should also be used as guide to those people around Australia setting Envoys for the Austravel
Safety Net Group's HF Radio Network.
20 Kiss Envoy Red Button
Once inside the Austravel EMERGENCY screen, it
should look something like this
8) "Arrow Down" to the last "EMERGENCY Ch" in
the list and press "OK".
9) "Arrow Down" to "Call Type" then "Left Hand
Arrow" across to "Send Position"
10) Press the "Save Button" then "Close"
11) Reboot the radio.
Page 3 of 3