Leviton EZ-MAX Plus 8 Quick Start Manual page 29

EZ-MAX Plus QuickStart.book Page 29 Thursday, January 22, 2009 1:55 PM
Configuring Inputs
On Voltage must be a voltage between 1-10 VDC, AND must
•
be less than the OFF voltage.
OFF Voltage must be a voltage between 1-10 VDC, AND must
•
be greater than the ON voltage.
Step 8: Enter the level, in volts, for which you desire these relays
to be activated when the light levels are FALLI NG (ON).
Press
Step 9: Enter the level, in volts, for which you desire these relays
to be deactivated when the light levels are RI SI NG (OFF).
Press
Step 10: Assign the relay (or relays) to this occupancy sensor.
Press
use the numeric keypad to enter a relay number. Press
to navigate to the next field and toggle I GNORE to
YES
if you want to assign the relay.
Step 11: Continue to use the
field and the behavior field, and cycle through all relays
until you have set all of them to YES or I GNORE. Press
Select/ Save
relays.
DI GI TAL I NPUT—Sw itch
The steps below show you how to manually input a digital switch
into the system. I f you install your digital switches first, and then
Page 29
Select/ Save.
PHOTOCELL
ON VOLTS: 4.0
Select/ Save
PHOTOCELL
OFF VOLTS: 6.0
or to cycle through the relay numbers, or
ASSIGN RELAYS
RELAY# 3:
when you have finished assigning all
EZ-MAX Plus Quick Start Guide
YES
to move between the RELAY