Leviton EZ-MAX Plus 8 Quick Start Manual page 25

EZ-MAX Plus QuickStart.book Page 25 Thursday, January 22, 2009 1:55 PM
Configuring Inputs
Step 5: Press
button. Press
Step 6: Assign a relay (or multiple relays) to the switch. Press
or
numeric keypad to enter a relay number. Press
navigate to the next field and toggle I GNORE to
you want to assign the relay.
Step 7: Continue to use the
field and the behavior field, and cycle through all relays
until you have set all of them to YES or I GNORE. Press
Select/ Save
relays.
I f you are configuring a multi-button switch, continue to repeat
the above steps until you've configured all buttons on the switch.
LV I NPUT—OCC
Configuring Occupancy Sensors
These instructions assume that your Occupancy Sensor is already
connected to one of the low voltage inputs.
Step 1: Press the
Step 2: Press
press
Page 25
or to choose a behavior for this particular
Select/ Save.
LV SWITCH TYPE
MOMENTARY
to cycle through the relay numbers, or use the
ASSIGN RELAYS
RELAY# 3:
when you have finished assigning all
MENU
button.
or until the display reads as below, then
SELECT/ SAVE.
MAIN MENU SELECT
CONFIG INPUTS
EZ-MAX Plus Quick Start Guide
YES
to move between the relay
to
YES if