goodnature X-1 MINI PRO Owner's Manual page 21

Section 7:
DISASSEMBLY AND CLEANING THE PARTS
1
With the machine "ON" and all components still assembled, press the SINGLE button and allow the press rod to
extend. Once extended, lift the grinder to the "Up" position to stop the press. Clean the press rod with a wet cloth
then wipe dry. Press the STOP button to retract the press rod.
2
Press the power switch to the "OFF" position, disassemble the grinder and place parts aside. For detailed
disassembly instructions, follow the steps in the "Setup" section in reverse.
3
We recommend rinsing the grinder in the "Down" position while the press chamber and an empty juice container
are in-place. The dirty water will collect in the juice container. Doing this step now will make cleaning the
machine easier.
4
Remove the press chamber with moving platen and juice container.
5
Take all parts to sink for washing and follow local health regulations for cleaning. This usually involves washing,
rinsing, and sanitizing.
WIPEDOWN
Leave pitcher until grinder base is wiped clean, this will minimize mess.
Drop
Wipe any remaining produce out of the grinder base.
Drop
Lower the shredder base to the "Down" position. Rinse the grinder base with water, it should collect in the pitcher.
Drop
Remove pitcher and wipe down machine.
X-1 MINI PRO OWNER'S MANUAL
ASSEMBLY & OPERATOR INSTRUCTIONS
Cleaning
21
25