Related Manuals for Atlas IED Strategy Series
Summary of Contents for Atlas IED Strategy Series
- Page 1 Owner’s Manual Surface Mount Loudspeakers Atlas Sound Strategy Series ® Surface Mount Loudspeakers SM42T-B SM42T-W SM52T-B SM52T-W SM82T-B SM82T-W – 1 – AtlasSound.com Specifications are subject to change without notice.
- Page 2 General Description All Atlas Sound Strategy Series speaker systems are designed to provide high fidelity, long life and installation convenience for com- mercial and residential applications. Because of their weather-resistant properties they are perfect for use indoors or out. The Atlas Sound Strategy Series surface mount speakers are available in 4", 5...
- Page 3 Owner’s Manual Surface Mount Loudspeakers Down Firing – – – 101dB – 101dB 100dB – – – – – – – – – – – – – – – – – – Note: Using the above spacing suggestions will maintain good, even high frequency coverage, which translates into excellent intelligi- bility for voice reproduction and high fidelity music reproduction.
- Page 4 It is the responsibility of the installer to insure that the speaker is installed accord- ing to those regulations. If the Strategy Series Surface Mount speaker is suspended, Atlas Sound strongly recommends that the sys- tem be inspected at least once a year.
- Page 5 Owner’s Manual Surface Mount Loudspeakers Painting the Speakers The injection molded, polypropylene, talc impregnated cabinets can be painted to match your décor. You should prime the cabinet with ™ After the primer coats are completely dry, paint the cabinets, brackets and knobs. Be careful not to paint the input terminals! Painting the Grilles 8Ω...
- Page 6 Surface Mount Loudspeakers Owner’s Manual Line Matching Transformer Connections check your local codes before installation. Ω CAUTION: Maintenance and Care a wall or ceiling, use a broom or duster to gently brush it off. Spraying the speaker with high-pressure water is not recommended and will void the warranty.
- Page 7 Owner’s Manual Surface Mount Loudspeakers Specifications SM42T Ω Transducer Complement ⁄ – 7 – AtlasSound.com Specifications are subject to change without notice.
- Page 8 Surface Mount Loudspeakers Owner’s Manual Specifications SM52T Ω Transducer Complement ⁄ ⁄ ⁄ ⁄ AtlasSound.com – 8 – Specifications are subject to change without notice.
- Page 9 Owner’s Manual Surface Mount Loudspeakers Specifications SM82T Ω Transducer Complement ⁄ ⁄ ⁄ – 9 – AtlasSound.com Specifications are subject to change without notice.
- Page 10 Surface Mount Loudspeakers Owner’s Manual Notes AtlasSound.com – 10 – Specifications are subject to change without notice.
- Page 11 Owner’s Manual Surface Mount Loudspeakers Notes – 11 – AtlasSound.com Specifications are subject to change without notice.
- Page 12 Surface Mount Loudspeakers Owner’s Manual Limited Warranty: All products manufactured by Atlas Sound are warrantied to the original dealer/installer, industrial or commercial purchaser to be free from defects in material and workmanship and to be in compliance with our published specifications, if any. years.
- Page 13 AA35G & AA60G Owner’s Manual Commercial Mixer Amplifier AA35G & AA60G Commercial Mixer Amplifier 1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A. Telephone: 800.876.3333 • Fax: 800.765.3435 – 1 – AtlasIED.com Specifications are subject to change without notice.
-
Page 14: Table Of Contents
AA35G & AA60G Owner’s Manual Commercial Mixer Amplifier Table of Contents Important Safety Instructions ........................3 Introduction ............................5 Key Features ............................5 Applications ............................5 Front Panel Description ........................... 6 Rear Panel Description ..........................7 Installation ............................... 8 Rack Mounting ............................8 Input Wire and Connections ........................ -
Page 15: Important Safety Instructions
AA35G & AA60G Owner’s Manual Commercial Mixer Amplifier Important Safety Instructions The lightning flash with arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage “ within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. - Page 16 AA35G & AA60G Owner’s Manual Commercial Mixer Amplifier WARNING - When The Device Is In Use • WARNING: For the terminals marked with symbol of may be of sufficient magnitude to constitute a risk of electric shock. The external wiring connected to the terminals requires installation by an instructed person or the used of ready-made leads or cords. •...
-
Page 17: Introduction
AA35G & AA60G Owner’s Manual Commercial Mixer Amplifier Introduction Congratulations and thank you for purchasing the AtlasIED AA35G/AA60G mixer amplifier. Small, compact, and engineered for reliability, the AtlasIED AA35G/AA60G will provide years of service and flexibility in background music and paging applications. Key Features •... -
Page 18: Front Panel Description
AA35G & AA60G Owner’s Manual Commercial Mixer Amplifier Front Panel 1. Input Signal Presence/Clip Indicators Green LED, one above each channel’s volume control, illuminates when input signal exceeds –40 dBu, and flashes brightly at threshold of audible distortion. 2. Master Level Control The Master Level control will raise or lower all the input channels together. -
Page 19: Rear Panel Description
AA35G & AA60G Owner’s Manual Commercial Mixer Amplifier Rear Panel 1. AC Power Inlet Detachable IEC accepts US or Euro style power cords. 2. Amplifier Outputs For loudspeaker connections, connect as follows or proceed to the setup section for typical wiring schemes. •... -
Page 20: Installation
AA35G & AA60G Owner’s Manual Commercial Mixer Amplifier 5. Line Output Connector 3-Pin Balanced Euroblock connector. Line level output is Pre Master Level control. Use this output to connect signal to a secondary amplifier. 6. Zone 2 Level Control Potentiometer adjusts level for both Zone 2 outputs. 7. -
Page 21: Input Wire And Connections
AA35G & AA60G Owner’s Manual Commercial Mixer Amplifier Choose Input Wire and Connectors AtlasIED recommends using balanced line (two-conductor plus shield), 22-24 gauge cables and connectors. Unbalanced line may also be used but may result in noise over long cable runs. The AA35G and AA60G have two types of input connectors: Euroblock and RCA. -
Page 22: Output Wire Connections
AA35G & AA60G Owner’s Manual Commercial Mixer Amplifier Choose Output Wire and Connectors Amplifier Output Connections: Slip the cable lugs under the output screw terminals and tighten (Figure 2.5). Slide the supplied non-touch cover over the output connections from top to bottom to cover them. AtlasIED recommends using high-quality, two-conductor, heavy gauge speaker wire and connectors. -
Page 23: Wiring The System
AA35G & AA60G Owner’s Manual Commercial Mixer Amplifier Wire the System Typical input and output wiring is shown in Figure 2.8. INPUTS: For Input 1, connect a microphone or balanced line-level signal to the Input 1 balanced input. Set the Mic/Line switch (DIP switch #1) accordingly. -
Page 24: Operation
AA35G & AA60G Owner’s Manual Commercial Mixer Amplifier Operation Powering Up 1. Turn Off any equipment connected to the Preamp Output connector. 2. Plug the amplifier’s power cord into a 3-wire grounded AC outlet. 3. Turn down the input volume controls. 4. -
Page 25: Troubleshooting
AA35G & AA60G Owner’s Manual Commercial Mixer Amplifier Troubleshooting CONDITION: No power to the mixer amplifier. POSSIBLE REASON: • The mixer amplifier’s power switch is Off. • The mixer amplifier is not plugged into the AC power receptacle. • The mixer amplifier’s high-voltage power supply circuit breaker has tripped. Verify that the AC mains voltage is correct. -
Page 26: Specifications
AA35G & AA60G Owner’s Manual Commercial Mixer Amplifier Specifications AA35G AA60G Electrical Specifications Power into 8 or 70V/100V Output (1kHz with 0.5% THD) Frequency Response (at 1 Watt from 8 Tap) 50Hz - 20kHz ±1 dB Technical Data Signal to Noise Ratio (Ref. to Rated Power, Master Volume at Minimum) Mic: >... - Page 27 AA35G & AA60G Owner’s Manual Commercial Mixer Amplifier Notes: 1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A. Telephone: 800.876.3333 • Fax: 800.765.3435 – 15 – AtlasIED.com Specifications are subject to change without notice.
-
Page 28: Warranty
AA35G & AA60G Owner’s Manual Commercial Mixer Amplifier Limited Warranty All products manufactured by AtlasIED are warranted to the original dealer/installer, industrial or commercial purchaser to be free from defects in material and workmanship and to be in compliance with our published specifications, if any. This warranty shall extend from the date of purchase for a period of three years on all AtlasIED products, including SOUNDOLIER brand, and ATLAS SOUND brand products except as follows: one year on electronics and control systems;...
Need help?
Do you have a question about the Strategy Series and is the answer not in the manual?
Questions and answers