Table of Contents
Advertisement
LTPH-SM-1052-04
U
T
SING THE
ERMINAL
You can use the Terminal Access Option (TAO) interface to access and manage all the components of the
HMS-358, including the line units, multiplexers, shelf, and the associated doublers and remote units.
Depending on the version of HMU software you are using, the logon procedure varies. At the time of this writing,
all versions of software respond to at least one of the logon procedures described below. Select the logon
procedure that applies and follow the instructions.
1 At the prompt, type
Procedure 1
2 At the "enter password" prompt, type
1 At the prompt, type
Procedure 2
2 After the message, "Please Log off TL1 session and retype TAO," type
semicolon (;).
3 After the "Logged out OK" message, type
4 At the password prompt, type
1 At the prompt, type
Procedure 3
2 After the message, "Please log on to local TL1 with proper privilege and re-type TAO," press
3 At the "Enter TID [local]" prompt, enter the ID (if necessary) or press
4 At the "Enter username" prompt, type
5 At the "Enter password" prompt, type
6 At the TL1 prompt (<), type
•
Upon successful logon to a single-shelf system, the Shelf Status screen appears
•
Upon successful logon to a multishelf system, the Network Status Screen appears
Select the shelf you wish to view. The Shelf Status screen appears.
If you forget your password, contact ADC Technical Assistance Center (see
Product Support" on page
manual.
?
Installer Signature
Contact the Technical Assistance Center (TAC) for information on using the Transaction
Language 1 (TL1) command line interface for the following command sets:
•
HXU-358 List 1 (M13) TL1 Command Set
•
HXU-359 List 1 (STS-1) TL1 Command Set
Proceed to
"Configuring the Management Unit" on page
HMS-358 List 5 and List 6
A
O
CCESS
PTION
, then press
ENTER
.
tao
public
, then press
ENTER
.
tao
, then press
tao
(default password) and press
public
ENTER
tao
, then press
.
superuser
public#1
and press
ENTER
tao
84). For more information about passwords, refer to the HMU user
29.
July 14, 2002
Installing a Management Unit (HMU)
(default password) and press
logoff
ENTER
.
ENTER
ENTER
.
(default username), then press
(default password) and press
.
(Figure 19 on page
ENTER
.
, and then type a
.
ENTER
.
ENTER
.
ENTER
.
28).
(Figure 18 on page
28).
"Appendix E -
Date
27
Advertisement
Table of Contents
