Table of Contents
Advertisement
Installing Multiplexers
Step
Procedure (Continued)
Line load, line type, and line buildout must match the HCU card in use.
These settings should be set to the default values.
If an HCC-319 List 1 and List 2 cut-through card is used, these settings should match
those of the external line connected to the port.
7
Select the Virtual Tributary Group (VTG) 1 through 7 and the Virtual Tributary Slot (VTS)
1 through 4. Only available combinations are presented for selection.
8
When finished configuring the port, reset the port to IS to place the line unit in service, then press
ENTER
.
9
Return to the Config menu by pressing
10
Proceed to
"Configuring the STS-1 Transport Through the Config Menu" on page
?
Installer Signature
Do not configure a service as OOS-M or OOS-A when it is selected as a clock synchronization
source.
48
ESC
.
July 14, 2002
LTPH-SM-1052-04
Installer Check ü
H
H
H
H
49.
Date
HMS-358 List 5 and List 6
Advertisement
Table of Contents
