Installing The Octal E&M Module; Figure 2-1. Installing The Octal E&M Module - ADTRAN Octal E&M User Manual

Chapter 2. Installation
INSTALLING THE OCTAL E&M MODULE
2-2
Figure 2-1 shows how to install the module properly. The instructions are
described in the Step/Action table, below.
Instructions for Installing the Octal E&M Module
Step
Remove the cover plate from the appropriate option slot in the
1
ATLAS 550 rear panel.
Slide the module into the option slot until the module is firmly
2
positioned against the front of the chassis.
Secure the thumbscrews at both edges of the module. Tighten
3
with a screwdriver.
4 Connect the cables to the associated device(s).
Complete installation of remaining modules and Base Unit as
specified in the Installation chapter of the ATLAS 550 User
5
Manual .
Option modules are intended to be serviced by qualified
service personnel only.
Octal E&M Module User Manual
Remove Cover Plate
Figure 2-1. Installing the Octal E&M Module
Action
O I
61200313L1-1