Table of Contents
Advertisement
Programming Barcode Data
Programming barcode data (e.g. WFFD980) can be transmitted to the Host. To enable this feature, scan
the barcode below. After the feature is enabled, programming barcodes will be handled as
non-programming barcodes and they cannot be used to configure the scan engine. The barcode data will
be sent to the Host when a programming barcode is scanned and decoded. By default, the EM2000 does
not transmit programming barcode data.
After the engine is powered down and re-energized, this feature will be automatically disabled (i.e. the
engine does not transmit programming barcode data) and the ability of programming barcodes to
configure the engine will be restored.
Factory Defaults
Scanning the following barcode can restore the engine to the factory defaults. See Appendix A: Factory
Defaults Table for more information.
Note: Use this feature with discretion.
27
Transmit Programming Barcode Data
Restore All Factory Defaults
Advertisement
Table of Contents
