Set The Sleep Timer; Adjust Display Brightness - Philips AJ7400 User Manual

Stop alarm ring
• When the alarm rings, press the
corresponding AL1 or AL2.
» The alarm stops but the alarm settings
remain.
Tip
•
If you press and hold /SOURCE, the alarm will also
be stopped, and the unit will switch to standby mode.
•
If you do not stop the alarm, it will ring for 30 minutes.
•
When an alarm rings, it begins from a relative low
volume, and rises gradually to the highest alarm volume
you set previously in 90 seconds.

Set the sleep timer

This unit can switch to standby mode
automatically after a set period of time.
Press SLEEP repeatedly to select from 120,
•
90, 60, 45, 30 and 15 minutes.
» When the sleep timer is activated,
shown on the screen.
To deactivate sleep timer
Press SLEEP repeatedly until [OFF] (off) is
•
shown.
» The sleep timer is deactivated,
disappears from the screen.

Adjust display brightness

• When no alarm is ringing, press
SNOOZE/BRIGHTNESS repeatedly to
select different levels of display brightness.
Note
•
When using batteries to operate, you can not select
brightness levels.
is
EN 13