Contents 1 Important 2 Your clock radio Introduction What's in the box Overview of the main unit Overview of the outdoor sensor 3 Get started Install battery Connect power Plug and set Select time zone Set clock 4 Listen to FM/MW radio Tune to radio stations Store radio stations automatically Store radio stations manually...
1 Important injury or death. Severe internal burns can occur within two hours of ingestion. • If you suspect that a battery has been swallowed or placed inside any part of the • Read these instructions. body, seek immediate medical attention. •...
2 Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this clock radio, you can: • listen to FM/MW radio; • set two alarms; • view time, date, and indoor/outdoor temperature;...
Overview of the main unit a AL1/AL2 d TIME ZONE • Set alarm. • Set time zone. • View alarm settings. e DISPLAY • Activate or deactivate alarm timer. • Activate temperature display setting b Display panel mode. • Show current information. f NATURE SOUND c DST • Activate nature sound setting mode.
h FM ANT Overview of the outdoor • Improve FM reception. sensor i TUNING MODE • Select tuning mode. j PRESET • Select a preset radio station. k FM/MW • Select FM or MW tuner mode. l SET TIME/PROG • Set time. • Program radio stations.
3 Get started Replace battery of the main unit Note Always follow the instructions in this chapter in • You can only use AC power as power supply. The pre- sequence. installed CR2032 battery can only back up clock and alarm settings.
Rotate the main knob to adjust hour. Press the knob to confirm. » The minute digits begin to blink. Repeat Steps 2-3 to set the minute, 12/24 hour format, year, month, day, and month- day display mode in sequence. • In time and date setting mode, if you press and hold the knob for 3 seconds, the clock radio will save the change and quit the setting mode.
4 Listen to FM/ Store radio stations manually MW radio Tune to a radio station. Press PROG. » The preset number begins to blink. Tune to radio stations Rotate the main knob to select a number. Press the knob to confirm. » [DONE] (done) is displayed. •...
5 Other features To change to Channel 2 or 3 to transmit RF signal: Press DISPLAY. Rotate the knob until the corresponding icon appears. Display indoor/outdoor Press the knob to confirm. temperature Switch the CHANNEL control to 2 or 3. » The main unit and sensor begin to Adjust temperature display detect signal from Channel 2 or 3 and then display the outdoor temperature.
To deactivate the sleep timer: Press the main knob to confirm. » The minute digits and [AL1]/[AL2] In sleep timer setting mode, rotate the knob blink. until [OFF] (off) appears, then press the knob. Repeat step 2-3 to set minute. Repeat step 2-3 to select whether to ring alarm for the whole week, on weekdays (Monday to Friday), or on the weekend (Saturday and Sunday).
If the problem remains unsolved, go to the Philips Web page (www.philips.com/support). When you contact Amplifier Philips, make sure that the device is nearby and the model number and serial number are Rated Output Power 0.6 W RMS available.
Koninklijke Philips Electronics N.V. or their device that are not expressly approved by respective owners. Philips reserves the right Philips Consumer Lifestyle may void the user’s to change products at any time without being authority to operate the equipment. obliged to adjust earlier supplies accordingly.