Page 1
PLA2FX 120W X 2 CLASS D Power Amplifier w/DSP OWNERS MANUAL...
Page 3
PLA2FX can be used in many PLA2FX can be used as a two channels, 2.1 different applications. channels, bridged as a 1 channel amplifier. FEATURE...
Page 4
3. PRE OUT: A buffered Line out is available to 8. LOW PASS FILTER (LPF): Set to OFF extend the audio signal to another PLA2FX position, the amplifier works as a stereo or other amplifier as needed. amplifier. Set to ON position, the amplifier works as a subwoofer amplifier.
Page 5
Input Impedance : >10k, unbalanced DSP GRAPHIC USER INTERFACE * Connect the Ethernet port of PLA2FX to the local network of router via standard Cat5 cable. * Save the DSP software to the PC properly, and run the software. * PLA2FX and control PC need to be at the same network.
Page 6
TYPICAL CONNECTION * Using single PLA2FX amplifier in stereo system shown as below: * Rack amount two linked PLA2FX amplifiers and work as 4 channels shown as below:...
Page 7
TYPICAL CONNECTION * Rack amount two linked PLA2FX amplifiers and work as 2.1 channels shown as below: LPF swtich “ON” and Bridged.
Need help?
Do you have a question about the PLA2FX and is the answer not in the manual?
Questions and answers