Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Biosan Automatic Luminescence Analyser ALA1/4
Summary of Contents for Biosan Automatic Luminescence Analyser ALA1/4
-
Page 3: Table Of Contents
Contents Safety Precautions ..................4 General Information ..................5 Getting started ....................6 Operation ...................... 7 Specifications ....................8 Maintenance ....................9 Warranty and Claims .................. 10... -
Page 4: Safety Precautions
Safety Precautions The following symbol means: Caution: Make sure you have fully read and understood the present Manual before using the equipment. Please pay special at- tention to sections marked by this symbol. GENERAL SAFETY Use only as specified in the operating manual provided. ... -
Page 5: General Information
General Information Multi channel rotor-type Fluorimeter developed for the end-point PCR prod- uct detection. It is a 4 channel high speed detector of Fluorescence/quenching ration of DNA probe conjugated with a fluorescence/quenching molecules. Level of fluorescence depends on a quantity of a positive amplification after thermocycling of DNA probes. -
Page 6: Getting Started
Warranty covers only the units transported in the original package. 3.2. Complete set. Package contents: Standard set Automatic Luminescence Analyser ALA1/4 .......... 1 pce. Spare fuse ................... 1 pce. Rotor for 0.5 ml tubes ................1 pce. Rotor for 0.2 ml tubes ................1 pce. -
Page 7: Operation
Operation 4.1. Connect the power cord to the mains outlet. 4.2. Switch ON the power switch on the rear. The analyser turns on and the display shows “ALA_X.XX.X”. Attention! It is necessary to allow 15 min time for warming up before conducting detection. -
Page 8: Specifications
5.14. Power consumption, no more than ............30 W 5.15. Dimensions 400х250х190 mm 5.16. Weight* ....................8.5 kg Biosan is committed to a continuous program of improvement and reserves the right to alter design and specifications of the equipment without additional notice. -
Page 9: Maintenance
Maintenance 6.1. If the unit requires maintenance, disconnect the unit from the electric circuit and contact Biosan or your local Biosan representative. 6.2. All maintenance and repair operations must be performed only by qualified and specially trained personnel. 6.3. Standard ethanol (75%) or other cleaning agents recommended for cleaning of laboratory equipment can be used for cleaning and decontamination of the unit. -
Page 10: Warranty And Claims
7.4. If any manufacturing defects are discovered by the Customer, an unsatisfac- tory equipment claim shall be compiled, certified and sent to the local distrib- utor address. Please visit www.biosan.lv, Technical support section to obtain the claim form. 7.5. The following information will be required in the event that warranty or post- warranty service comes necessary. - Page 12 SIA Biosan Ratsupites 7, build. 2, Riga, LV-1067, Latvia Phone: +371 6742 6137 Fax: +371 6742 8101 http://www.biosan.lv Edition 2.01 – October 2015...
Need help?
Do you have a question about the Automatic Luminescence Analyser ALA1/4 and is the answer not in the manual?
Questions and answers