Installation Manual
H3C S9500 Series Routing Switches
The rack-mounting ears are well fixed on the
switch.
The installation position is right.
The rack-mounting ears are well fixed on the
rack
3.4 Installing the Switch on a Workbench
When no 19-inch cabinet is available, you can place the switch on a clean
and stable workbench.
3.4.1 Preparations
Make sure that the workbench is sturdy enough to bear the weight of
the switch and cables.
Make sure that the workbench is flat and well grounded.
3.4.2 Procedure
Lift the switch onto the workbench with another person.
Caution:
Reserve at least 15.2 cm (6.0 in.) of clearance around the switch for heat
dissipation.
3.5 Connecting the PGND Wire
Caution:
For the safety of operators and equipment, the switch must be well
grounded. The resistance reading between switch chassis and the ground
must be less than 1 ohm.
Item
3-4
Chapter 3 Installing the Switch
Result
Remarks
Yes
No