Putting Into Service; General Start-Up Information; Start-Up Prerequisites; Turning On The Unit - Kendrion Vico MT 727 User Manual

Kendrion Kuhnke Automation GmbH

4.3 Putting into Service

General Start-up Information

CAUTION
Risk of burns
The surface of the device may become very hot. Unprotected contact causes a risk of burning
yourself.
 Avoid direct contact with the unit in operation. Put on suitable safety gloves before
touching the unit.
NOTE
Pull of the protective film to the side
 The protective film on the front removes easily by pulling it off to the side.
Touch screen operation
Operate the touch screen objects by touching them with your finger or a suitable stylus.
NOTE
Damage to the touch screen by pointed or hard objects
Destruction of front
Do not use pointed or hard objects to operate the touch screen.
 Avoid sudden or impact-like touch screen contact by hard objects because this may
destroy the touch screen. Touch the screen of Touch with your finger or the stylus only.

Start-up Prerequisites


Functional earth is connected.

All cables are attached properly.

Power is supplied to the unit.

Turning on the Unit

Connect the unit to the power supply.
The unit does not have an On/Off switch. Instead, it will start up automatically when you turn on the power
supply. The user interface of the operating system displays after the boot-up routine.

Turning off the Unit

You may directly unplug the unit from the power supply.
Vico MT (E 863 GB)
01/10/2021
Construction and Functionality
33