Front Panel Opening - Kendrion Vico MT 727 User Manual

Kendrion Kuhnke Automation GmbH

Front Panel Opening

•
Cut an opening into the control panel area where you wish to install the unit. Refer to the appropriate
drawing or table to find the correct dimensions.
7'' display panels
•
Approaching the switching cabinet from the front, slide the unit into the opening and gently push it all the
way in until it contacts the cabinet front.
•
At the back: Place the mounting hardware (1) in the T slots on the side (2) and laterally slide them in (3)
until the snap into place.
•
Go to the first piece of mounting hardware in a corner and tighten the screw (4) until it pushes against
the cabinet panel. Tighten the screws to max. 0.2 Nm.
•
Repeat at the mounting element opposite and across.
•
Repeat the crosswise procedure on the remaining elements.
Vico MT (E 863 GB)
01/10/2021
Front Panel Opening
Model
Vico MT 727
Vico MT 1027
Vico MT 1527
* Please note the drawing
Construction and Functionality
B
A
Width A
189.7 mm
252 mm
395.5 mm
Height B
121.5 mm
174.5 mm
244.5 mm
29