Connect The Charger; Figure 5. Connect To Versicharge Charger - Siemens VersiCharge AC User Manual

7.
Click Next to continue the configuration.

3.2 Connect the Charger

The status of the charger can be monitored by the color of the LED notifications shown on the charger display.
The different LED notification types are listed in the table below:
Description of Sequence
Power up
Software loading
Software running
Charger in Access Point (AP) mode
Receiving connection credentials
Received connection credentials
Connecting to network
Connected to network
Connecting to VersiCloud
Connected to network, registered, and connected to VersiCloud
Before charger connection ensure the following:
• Ensure the Wi-Fi connection between the charger and the commissioning device is enabled and active at the
commissioning/configuring device. For better stability, use 2.4GHz-type Wi-Fi network
• The Wi-Fi LED is blinking white on the charger (this indicates the charger is in Access Point (AP) mode).
• The Wi-Fi endpoint of the charger is available for connection. The serial number, found on the charger label, is a
connection choice.
NOTE: If Internet setup has been already configured in VersiCharge Configurator application with one of the modes,
configuring it with any other mode will override the existing configuration.
Perform the following steps to connect to the charger:
1.
Register the charger.
For more information, see section
2.
Connect to the Wi-Fi endpoint of the charger that will be used for configuration/commissioning.

Figure 5. Connect to VersiCharge Charger

3.1 Register the Charger.
User Manual VersiCharge™ AC Configuration Tool
LED Color
Grey Blinking
Red Blinking
Yellow Blinking
White Blinking
White Blinking
Green Blinking
Green Blinking
Green Steady
Blue Blinking
White Steady
7