COMGROW CNC Carving Machine User Manual page 2

Catalog
Disclaimers
01
Welcome
02
Characteristics
03
Contents
04
Assembly
05
Wiring schematic
06
Mainboard Module
07
Install Driver & Software
08
09 Operation precautions
Tool setting gauge block
10
Off-line controller
11
Laser engraving
12
Routine maintenance
13
Q&A
14
Routine maintenance
Disclaimers
Before operating the ROBO CNC, please read the instruction manual carefully. This is to
avoid undesirable results that may damage the CNC machine or cause personal injury.
01
Anyone operating a CNC machine should know and understand the content of this
manual.
02 1. COMGROW cannot verify and ensure that you are assembling the ROBO CNC correctly. We are not
responsible for and expressly disclaim liability for loss, injury, damage or expense associated with the
assembly, handling, storage, use or other disposal of the product.
2. The information in this manual is provided without warranty of any kind, either expressed or implied.
03
3. Please be careful when using the CNC machine. This machine is an electrical device with moving parts and
dangerous areas.
04
4. The ROBO CNC machine is for indoor use only.
5. You must be 18 or older to operate this machine, unless under the supervision of an adult skilled in the
use of this machine.
05
6. Please wear appropriate personal protective equipment (safety glasses, etc.).
7. Please place the CNC machine on a stable surface.
09
8. ROBO CNC machine provides switchable power supply 230 VAC or 110 VAC. It is forbidden to use different
power supply, it may lead to machine malfunction or even damage.
12
9. Please make sure that the emergency stop button is functional at all times.
10. Do not disassemble the power supply or electrical components. This will void the warranty.
14
11. Do not touch the machine spindle or place any body part near the work area while the machine is
running.
22
12. Please do not allow children near the machine, as damage may occur even if the CNC machine is not
working.
13. Please do not run the machine unattended.
24
14. Please make sure your CNC machine is in a well ventilated area. Some materials may emit fumes during
operation.
23
28
31
32
01