Advertisement
Place the Hard Cover Basic
with Wrapping Clamps with the
personalised cover down on the
table. Use the Wrapping Clamps to
align the Mirror Sheets. Be aware to
avoid that the Mirror Sheet sticks
to the protection frame by placing
the Mirror Sheet with the glossy
side (melt side) down. If your Hard
Cover Basic has binding resin in the
middle, protect the resin with the
Silicon Protection Paper.
Lower the protection frame and
close the tray to start pressing.
As soon as the tray is locked the
display shows a pictogram blinking:
pressing is in process.
A beep indicates the end of the
pressing cycle. Now the sides are
wrapped and the Mirror Sheets are
glued to the Hard Cover Basic.
Open the tray and lift the protection
frame. Place the softpad on top of
the Hard Cover Basic with the mirror
sheets and do a second pressing.
A beep indicates the end of the
pressing cycle.
Remove the wrapping clamps, and
your Hard Cover Basic is ready.
16
Advertisement
