Advertisement
Creating a Hard Cover Basic with the
Hard Cover Maker 650
(gluing the cover material)
14
Open the tray, and lift the protection
frame.
Place your Hard Cover Basic with
the hot melt side (glossy side) up
and place it on the middle of the
table.
Place the Positioning Corners on
the two opposite corners of the
Hard Cover Basic.
Place the printed cover material
with the printed side facing
upwards, on top of the Hard Cover
Basic. Align it to the Positioning
Corners
Lower the protection frame and
close the tray. The display will show
a pictogram blinking. Pressing is in
process.
A beep indicates that the pressing
cycle is over. Open the tray, and lift
the protection frame.
Advertisement
