Chrysler Pacifica Hybrid 2022 Manual page 32

Table of Contents

Advertisement

30
GETTING TO KNOW YOUR INSTRUMENT PANEL
O
L
R
IL
IFE
ESET
Your vehicle is equipped with an engine oil
change indicator system. The "Oil Change Due"
message will display for approximately five
seconds after a single chime has sounded, to
indicate the next scheduled oil change interval
has been reached. The engine oil change indi-
cator system is duty cycle based, which means
the engine oil change interval may fluctuate,
dependent upon your personal driving style.
Unless reset, this message will continue to
display each time the ignition is cycled to the
ON/RUN position.
To reset the oil change indicator, refer to the
following procedure.
NOTE:
This procedure should only be performed after
scheduled maintenance is completed. Resetting
oil life other than when associated with a
scheduled maintenance may result in damage due
to not properly maintaining the engine oil.
1. Without pressing the brake pedal, push the
ENGINE START/STOP button and place the
ignition in the ON/RUN position (do not start
the vehicle).
2. Push and release the up
arrow button until the menu displays the
"Vehicle Info" screen.
3. Push the left
arrow button or right
arrow button to access the "Oil Life" submenu.
4. Hold the OK button to reset the "Oil Life" to
100%.
NOTE:
This procedure must be completed within one (1)
minute of changing the ignition mode from OFF to
RUN. Otherwise you will need to cycle the ignition
to OFF and then back to RUN again (this is to
prevent inadvertent resetting of the oil life).
Secondary Method For Oil Life Reset Procedure
1. Without pushing the brake pedal, place the
ignition in the ON/RUN position (do not start
the engine).
2. Fully press the accelerator pedal, slowly, three
times within 10 seconds.
3. Without pushing the brake pedal, place the
ignition in the OFF position.
NOTE:
If the indicator message illuminates when you start
the vehicle, the oil change indicator system did not
reset. If necessary, repeat this procedure.
F
A
UEL
ND
or down
Since it is possible to operate this vehicle for
extended periods of time without running the gas
engine, the fuel within the vehicle's fuel tank can
become stale or the engine oil's lubricating
properties can be reduced. To prevent engine and/
or fuel system damage due to stale fuel, as well as,
maintaining internal engine lubrication, this
vehicle is equipped with a "Fuel and Oil Refresh
Mode".
The vehicle will automatically enter into the Fuel
and Oil Refresh Mode to minimize potential for
stale fuel, and to ensure lubrication of internal
engine components. When operating in this mode,
the gas engine will run to provide vehicle
propulsion (electric only operation is inhibited).
A message will be displayed in the instrument
cluster whenever Fuel and Oil Refresh Mode is
active.
The vehicle will automatically exit the Fuel and
Oil Refresh Mode when conditions have been
satisfied. If the vehicle enters Fuel and Oil Refresh
Mode, due to fuel which has been in the fuel tank
for a long period of time (becoming stale fuel), the
engine will run whenever the vehicle is operational
(no electric only operation) until the low fuel level
warning is activated. It is also possible to exit the
Fuel and Oil Refresh Mode sooner by adding a
minimum of four gallons of new fuel to the
vehicle's fuel tank.
O
R
M
IL
EFRESH
ODE

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents