Chrysler Pacifica Hybrid 2022 Manual page 26

24 GETTING TO KNOW YOUR VEHICLE
T E R S M
O XIT EMOTE TART
Push and release the Remote Start button one
time or allow the Remote Start cycle to complete
the entire 15 minute cycle.
In addition, the ignition can be cycled to the
RUN (Pre-Propulsion System Active) position by
pressing the ignition button with the key fob in the
vehicle, and then pushing the ignition button one
more time to place the ignition in the OFF position.
NOTE:
To avoid unintentional shutdowns, the system will
temporarily disable for two seconds after receiving
a valid Remote Start request.
Refer to the Owner's Manual for further
information.
S C C
CHEDULED ABIN ONDITIONING
(SCC)
This feature allows the driver to pre-condition
(warm up or cool down) the passenger cabin based
on a planned departure time. The target
temperature is preset to the same values used by
the Remote Start feature. Unlike Remote Start, the
driver does not need to initiate the cabin
conditioning by pushing the Remote Start button,
instead, a programmed departure time will be
used. Also, all scheduled cabin conditioning will be
powered by the vehicle's high voltage battery
ODE
working in conjunction with any EVSE connected to
the vehicle. Unlike Remote Start, in SCC the
vehicle's gas engine will not start to provide power
or heat for cabin conditioning.
In order to conserve the vehicle's high voltage
battery power, the driver can choose between
allowing the battery to be drained of power down to
<1%, or to stop the SCC when the high voltage
battery has been depleted to 25% State Of Charge
(SOC). The battery percentages are displayed in
the instrument cluster display.
A maximum of three independent schedule event
timers are available for use by the SCC feature and
Scheduled Charging feature for charging the high
voltage battery. The timers may be used in any
combination for SCC and Scheduled Charging, but
only three total timers are available.
The SCC event times are used to wake up the
vehicle so that the Climate Control system can
condition the passenger cabin prior to the
scheduled departure time. Based on vehicle
operating conditions, ambient temperature, and
the next programmed departure time, the vehicle
will determine when to begin cabin conditioning.
Cabin conditioning can begin up to 30 minutes
prior to the scheduled departure time, provided the
stated high voltage battery conditions are met.
The SCC will continue for a maximum of
15 minutes after the scheduled departure time.
Once a scheduled event has been created, it can
be applied to one or more days of the week. The
scheduled event can also be set to occur only
during the current week, or repeat every week until
the feature is turned off or the event is changed.
All of the following conditions must be met before
the vehicle will initiate a scheduled SCC event:
Gear selector in PARK

Doors Closed

Hood Closed

Liftgate Closed

Hazard switch off

12 Volt battery at an acceptable charge level

Key fob not located inside the vehicle

Ignition in the OFF position

Remote Start has not been activated
