Parallel Port 1 Connector (Cn3); Primary Ide Hard Drive Connector (Cn4) - Aaeon HSB - 660S/I Manual

2.15 Parallel Port 1 Connector (CN3)

Pin
1
3
5
7
9
11
13
15
17
19
21
23
25

2.16 Primary IDE Hard Drive Connector (CN4)

Chapter 2 Quick Installation Guide
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
H a l f - S i z e C P U C a r d
Signal
STBX
PTD0
PTD1
PTD2
PTD3
PTD4
PTD5
PTD6
PTD7
ACK#
BUSY
PE
SLCT
You can attach one or two Integrated Device Electronics hard disk
drives to the HSB-660S/I internal controller. The HSB-660S/I IDE
controller uses a PCI local-bus interface. This advanced interface
supports faster data transfer.
Connecting the hard drive
Connecting drives is done in a daisy-chain fashion requires one of two
cables, depending on the drive size.
Wire number 1 on the cable is normally red or blue, and the other wires
are usually gray.
1. Connect one end of the cable to CN4, and make sure the red (or
blue) wire corresponds to pin 1 on the connector, which is labeled
on the board (on the right side).
H S B - 6 6 0 S / I
Pin Signal
2 AFD#
4 ERR#
6 PINIT#
8 SLIN#
10 Ground
12 Ground
14 Ground
16 Ground
18 Ground
20 Ground
22 Ground
24 Ground
26 N/C
2 - 13