Set Up The Control Head; Confirm Connections - Humminbird MEGA 360 UNIVERSAL Installation Manual

Set Up the Control Head

When the control head detects the MEGA 360 Imaging transducer, it will select it
automatically as the 360 sonar source. The related views and menus will be added
to the system.
Use the following instructions to power on the control head and confirm the MEGA
360 Imaging transducer is detected by the unit.
CAUTION! It is important to finish all installation connections before powering on
the control head.
1. Confirm Connections
APEX/SOLIX Series
1. Turn on the power source from the main switch.
2. On the control head, press and hold the POWER key. If you are powering on
a control head in a multiple-control head Ethernet network, power on the
control head that is connected to the MEGA 360 Imaging transducer first.
3. Select Normal mode.
4. Review the status bar in the top, right corner of the screen to confirm the
sensor status for the MEGA 360 Imaging transducer is connected.
MEGA 360 Status Icon Icon Description
Connected/In Water/Pinging: The MEGA 360 is
connected, in the water, and pinging.
Connected/In Water/Not Pinging: The MEGA 360
is connected and in the water, but it is not pinging.
Connected/Out of Water: The MEGA 360 is
connected, but the wet indicator is out of the water.
Connection Lost: The connection to the MEGA
360 was lost.
17 Control Head Setup