Fishing System Defaults To Simulator With A Transducer Attached - Humminbird MEGA 360 UNIVERSAL Installation Manual

Fishing System Defaults to Simulator with a Transducer Attached

In addition to the MEGA 360 Imaging accessory transducer, you will have a standard
Humminbird transducer connected to the control head. A connected and functioning
transducer with built-in temperature will cause the newly-started Fishing System to
go into Normal operating mode automatically. If, when you power up the Fishing
System, it goes into Simulator mode automatically, even though a transducer is
already connected, this means that the control head is not detecting the transducer.
Perform the following troubleshooting tasks:
• Check the connections of all transducers that are connected to the control
head or Ethernet network. See the transducer installation guide that was
included with your Fishing System for connection information.
• Review this MEGA 360 Imaging installation guide to confirm that the
transducer cable is connected correctly to the Fishing System. Reconnect if
necessary, and power on the Fishing System again to see if this fixes the
problem.
• Replace the non-functioning transducer with a known good transducer if
available and power up the control head again.
• Check the transducer cable. Replace the transducer if the cable is damaged
or corroded.
Troubleshooting 28