Table of Contents
Advertisement
Agilent E6474A User's Guide
Configure the network and dial-up connection
Instructions for configuring the network and dial-up
Connection are included with the phone's documentation.
Follow the instructions explicitly. There are two parts to this
procedure:
• Setting up the Internet Connection: In this part of the
procedure, you set up the dial-up connection to your service
provider. You need your service provider's phone number.
• Advanced Connection Properties: In this part of the
procedure, you set up the Dial Up Networking (DUN)
properties, including the DNS and APN settings for your ISP.
This information is available from your service provider.
It is recommended that you use a logical (and meaningful) name for the
NOTE
DUN connection name. You will select this as the Dial-up Name when you
configure the Data Port Properties in the E6474A software. For example,
include the phone type, service provider name, and Data Port connection
number: Sagem-MyProvider-COM3.
Testing the phone/modem configuration
The following test verifies that all phone and modem settings
are correct:
1 Using the dial-up connection you have set up, establish a
connection with the Internet.
Not all phones have integrated data and power supply connections.
NOTE
Ensure the phone is fully charged before proceeding. Connect the phone to
a serial port of the computer, using the recommended connections given
to you by the phone supplier.
2 Open the browser on the computer.
3 Attempt to browse the web.
4 If this test is successful, then start the E6474A software, and
proceed to
"Adding a data device"
Use Your System
on page 90.
4
89
Advertisement
Table of Contents
