Table of Contents
Advertisement
Identifying devices
Agilent E6474A User's Guide
The software must identify the attached devices before it can
communicate with them. Devices include phones, Agilent digital
receivers, and the navigator (if equipped). This process is also
referred to as "configuring the system."
Generic data devices are configured differently than phones used in
NOTE
conversation mode. See
information.
If you are using the E6473B hub and are uncertain about which COM ports
NOTE
are assigned and need assistance in determining which COM port is
assigned to each specific device, refer to
installation"
More information on identifying devices and system
configuration can be found in the online help and quick basics.
Refer to
"Generic data devices"
on page 32.
"Get results fast"
on page 93.
Use Your System
on page 88 for setup
"Verifying E6473B hub
4
81
Advertisement
Table of Contents
