Johnson Controls T9200 Installation Manual page 5

T9200
Callout Feature
A Cooling
B
Heating
C Ventilation
D Auto mode
E
Fan auto
F Fan speed Hi/Med/Low
G
Tio2/ESP
H Floor heating
I Occupancy
INSTRUCTIONS
On/Off Setting: Press to turn on, press again to turn off, close the fan and valve.
Mode Selection: Press M to change the working mode,
heating mode. is available only for 4-pipe application or 2-pipe application when BI-FUNCTION is Change Over Sensor
input.
Temperature Setting: Press either
Fan Speed Adjustment: Press
Note: Fan stops at Floor Heating Mode, until FH-FAN parameter set to enable, for single stage floor heating application only.
Delay On/Off setup: Press and hold
then press or to adjust the minute by 30 minutes.
Note: Time-On/Off setting performs only once within one day.
Delay On/Off Cancel: Press and hold
delay time, then press
Lock setup: If Lock function is enabled, the thermostat locks automatically after 30 seconds unused.
Unlock function: Press and hold the
Tio2/ESP Manual: When Tio2/ESP function is set to Manual, press
P/N 24-11446-00018 Rev. B Issue Date: 11 2020
or button to increase or decrease the temperature by 0.5°C/1°F.
to switch the fan mode, auto
button 5 seconds, then "ON" appears, press
button 5 seconds, then "ON" appears, press
or adjust the time to "00:00".
button 5 seconds to unlock.
Callout Feature
J Alarm
K
Lock
L Valve status
M Remote sensor
N
Compressor protection
O Delay time
P
Temperature and humidity value
Q Low temperature protection
R Dehumidify
for cooling, for heating,
flash, high , medium
button once, to switch Tio2/ESP On or Off.
English
for venting, for auto cooling or
, low fan.
button to switch On or Off delay,
button to switch to check On or Off