Contec SP10W User Manual page 18

Instructions and declaration of the manufacturer - electromagnetic emissions -
Instructions and declaration of the manufacturer - electromagnetic radiation
is intended for use in the electromagnetic environment specified below. The user of the
The SP10W
must ensure that it is used in such an environment
Emission tests
emission
RF
CISPR 11
emission
RF
CISPR 11
Instructions and declaration of the manufacturer - resistance to electromagnetic interference -
Instructions and declaration of the manufacturer - resistance to electromagnetic interference
The SP10W is intended for use in the electromagnetic environment specified below
must ensure that it is used in such an environment
Resistance test
Electrostatic discharge
(ESD)
IEC 61000-4-2
Power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
Instructions and declaration of the manufacturer - resistance to electromagnetic interference -
Instructions and declaration of the manufacturer - resistance to electromagnetic interference
The SP10W is intended for use in the electromagnetic environment specified below
must ensure that it is used in such an environment
Test level IEC
Resistance test
60601
RF radiation
IEC61000-4-3
Telehealth medical diagnostic system IDIS2GO
for all DEVICES AND THE SYSTEM
Conformity
Group
1
Class B
for all DEVICES AND THE SYSTEM
Test level IEC60601
±6 kV contact
±8 kV air
3 A/m
for all DEVICES AND THE SYSTEM that do not need POWER
Level of
compliance
3 V/m 3 V/m
80 MHz to 2,5
GHz
Appendix I
.
Electromagnetic environment
uses RF energy only for internal function.
SP10W
Therefore, its RF emissions are very low and probably do
not cause any interference in the neighbouring electronic
equipment .
is suitable for use in all institutions, including
SP10W
domestic institutions and those directly connected to the
public low-voltage power supply network in buildings,
which is used for indoor needs.
.
Level of compliance
±6 kV contact
±8 kV air
3 A/m
.
Electromagnetic environment
The device for manual or mobile radio
communication should be used no closer to any
part of the SP10W , including cables, than from
the recommended distance, which is calculated
from the equation applied to the transmitter
frequency.
Recommended separation distance
18
SP10W
. The user of the SP10W
Electromagnetic
environment (instruction)
Floors should be wooden,
concrete or made of
ceramic tile.
If the floor is covered with
synthetic material, the relative
humidity should be at least
30%.
The quality of the power
supply must be
standardised,
commercial or hospital
environment.
. The user of the SP10W
(instruction)