Chapter 3 Maintenance And Component Installation; Removing Power; Accessing The System; Side Covers - Supermicro 530AD-I User Manual

Maintenance and Component Installation
This chapter provides instructions on installing and replacing main system components. To
prevent compatibility issues, only use components that match the specifications and/or part
numbers given.
Installation or replacement of most components require that power first be removed from the
system. Please follow the procedures given in each section.

3.1 Removing Power

Use the following procedure to ensure that power has been removed from the system. This
step is necessary when removing or installing non hot-swap components or when replacing
a non-redundant power supply.
1. Use the operating system to power down the system.
2. After the system has completely shut-down, disconnect the AC power cord(s) from the
power strip or outlet. (If your system has more than one power supply, remove the AC
power cords from all power supply modules.)
3. Disconnect the power cord(s) from the power supply module(s).

3.2 Accessing the System

The 530AD-I has two removable side covers. Except for short periods of time, do not operate
the system without the cover in place. The chassis cover allows proper cooling airflow.

Side Covers

Removing a Side Chassis Cover
Begin by removing power from the system as described in Section 3.1.
1. Remove the two thumb screws on the rear of the chassis.
2. Slide the cover toward the rear of the chassis.
3. Remove the cover from the chassis.
Warning: Except for short periods of time, do not operate the workstation without the cover in
place. The chassis cover must be in place to allow for proper airflow and to prevent overheating.
Chapter 3: Maintenance and Component Installation
Chapter 3
20