Table of Contents
Advertisement
Maintenance and Component Installation
This chapter provides instructions on installing and replacing main system components. To
prevent compatibility issues, only use components that match the specifications and/or part
numbers given.
Installation or replacement of some components require that power first be removed from the
system. Please follow the procedures given in each section.
3.1 Removing Power
Removing System Power
Use the following procedure to ensure that power has been removed from the entire system.
1. Use the operating system to power down all nodes.
2. After all nodes have powered down, disconnect the AC power cords from the power
strips or outlets, then disconnect them from the system power supply units.
Removing Power from a Node
Use the following procedure to remove power from a single node. This step is necessary
when removing or installing non hot-swap components to a node or when replacing a node.
1. Use the operating system to power down the node.
2. After the node has completely shut-down, access the node tray as described in the next
section.
Chapter 3: Maintenance and Component Installation
Chapter 3
27
Advertisement
Table of Contents
Troubleshooting
