Default Symbologies; Character Formats And Microbar Nx Transmission Format - Intermec MicroBar NX Reference Manual

Symbologies

Default symbologies

Code 39 and the UPC/EAN code families are preselected by default.
When you install and set up your MicroBar NX for the first time, all
the symbology parameters are set to their factory default settings—
indicated by an asterisk (*) in this manual.
The symbology default settings are global factory defaults—they are independent of the
different symbology activation codes.
If you want to reset all the default symbology settings, you can scan the Reset Factory
Defaults bar code (
completely reconfigure your MaxiScan 2200. It is often easier to scan Disable All
Symbologies and reactivate individual symbologies (
Keep a list of your custom settings—this will be useful if you have to perform a reset.

Character formats and MicroBar NX transmission format

symbology
Code 39
Code 93
Code 128
Telepen
Ames Code
Codabar
Code 11
Interleaved 2 of 5
Matrix 2 of 5
Standard 2 of 5
UPC/EAN code set
144
Reset all configuration parameters ), but you will then have to
character format supported
alphanumeric—letter case not
defined
alphanumeric full ASCII—letter
case defined
numerical
Symbologies—Activation ).
MicroBar NX transmission
format
upper case
full ASCII—lower case/upper
case as defined
numerical
MB/NX/RM/00/E/970131