Reset All Configuration Parameters; Reset Factory Defaults - Intermec MicroBar NX Reference Manual

Reset all configuration parameters

Reset all configuration parameters

Reset factory defaults

Reset Factory Defaults resets all the MicroBar NX parameters to their factory default
settings (indicated by "(*)" in this manual):
null interface (no host system interface driver selected—no transmission),
default symbology settings and operating settings.
Parameter list / data strings provides the full list of parameters and default settings.
If you scan Reset Factory Defaults, you will have to re-enter the appropriate
interface number for your host system and any custom settings if applicable—keep a
list in case you have to do a reset. It is often easier to reset individual parameters.
General reset procedure
1. Switch off the host system and disconnect the MicroBar NX power
supply if applicable.
2. Reconnect the MicroBar NX power supply if applicable.
3. Switch on the host system.
4. Use your barcode reader to scan Reset Factory Defaults.
5. Scan the interface number for your system (
numbers for your interface or Compose interface number).
6. Customize the settings for output transmission to your host system if
required (
7. Customize
(
devices, RS-232 input devices).
8. Customize the MicroBar NX operating settings if required
(
entries).
112
Data transmission parameters for your interface).
the data
Symbologies, Laser scanner input devices, Magstripe input
Parameter list / data strings and individual operating parameter
Reset Factory Defaults
input parameter settings
Predefined interface
if required
MB/NX/RM/00/E/970131