Power Up The Gateway - MSA fieldserver EZ Series Operating Manual

4

Power up the Gateway

Check power requirements in the table below:
Power Requirement for EZ Gateway External Gateway
EZ Gateway Family
FS-EZ3-MOD-BAC (Typical)
FS-EZ4-MOD-BAC (Typical)
NOTE: These values are 'nominal' and a safety margin should be added to the power supply of the host system.
A safety margin of 25% is recommended.
Apply power to the EZ Gateway as shown below. Ensure that the power supply used complies with the specifications
provided in Section 11.3 Specifications
• The gateway accepts 9-30VDC or 24VAC on pins L+ and N-.
• Frame GND should be connected.
12
Current Draw Type
12VDC
250mA
250mA
.
EZ Gateway Modbus to BACnet Start-up Guide
24VDC/AC
125mA
125mA