Intermec PB50 User Manual page 36

Chapter 2 — Configuring the PB50
28
4 From the host PC, check the wireless settings.
If you have an IPL version of the printer, send these
commands to the PB50:
<STX><SI>wt,SSID<ETX>
<STX><SI>wt,WEP1<ETX>
<STX><SI>wt,WEP2<ETX>
<STX><SI>wt,WEP3<ETX>
<STX><SI>wt,WEP4<ETX>
<STX><SI>wt,AUTH<ETX>
<STX><SI>wt,WPA<ETX>
<STX><SI>wt,WPA2<ETX>
<STX><SI>wt,WPA_PSK<ETX>
<STX><SI>wt,ROAM<ETX>
<STX><SI>wt,PWR_MODE<ETX>
<STX><SI>wt,CHANNEL<ETX>
<STX><SI>wt,AP_MAC<ETX>
<STX><SI>wt,SIGNAL<ETX>
<STX><SI>wt,SPEED<ETX>
<STX><SI>wt,ACTIVE<ETX>
If you have a Fingerprint version of the printer, send this
command to the PB50:
setup write "wlan","uart1:"
5 Set up the PB50 to use the correct SSID and authentication
modes. See one of the following procedures to configure
wireless printing on your IPL or Fingerprint printer.
6 If you are going to use certificates for validation, transfer the
certificate to the printer. The printer can accept .pfx, .pem,
and .der certificates.
7 Verify that the PB50 is connected to the access point and
make sure it has an IP address allocated to it.
To view the strength of your wireless connection
• Press the Information button.
The printer cycles through some of the key communication
information including 802.11 signal strength.
Use the following sections to set most of your wireless
communication settings. For help with additional commands
and information, see either the Fingerprint Programmer's Reference
Manual (P/N 937-005-xxx) or the IPL Programmer's Reference
Manual (P/N 937-007-xxx). You can download both documents
from the Intermec web site at www.intermec.com.
PB50 Mobile Label Printer User's Guide