Intermec PB2 User Manual page 15

PB2 Mobile Printer User's Guide
To remove the battery
Unlock and open the battery door and tip the printer to one side
•
to remove the battery.
To charge the battery with the AC adapter/charger
1 Plug the AC adapter into the power connector.
2 Install the appropriate AC plug on the adapter. The adapter comes
with four different plugs suitable for most regions worldwide.
3 Make sure the printer is off and connect the adapter to AC power.
The Battery LED turns on, indicating that the battery is charging.
Note: If the other LEDs turn on, press the Power button to turn
the printer off.
After about three hours the Battery LED turns off. The battery is
fully charged.
Note: The wall mounted charger is Class II equipment. Multiple
plug configurations comply with most international standards.
The wall mounted charger is not supplied with plugs for use in
Korea.
Using the 2-Bay Battery Charger
Use the 2-bay battery charger to charge the batteries.
To use the 2-bay charger
1 Plug the AC adapter into the 2-bay charger.
12
11 1
10 2
9
3
8
4
7
5
6
5