Page 1
ASSEMBLY INSTRUCTION SMITHERS 1 Drawer Bedside ITEM CODE 69423 Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia. For any assistance with assembly or for missing parts please refer to your receipt...
PRE-ASSEMBLY PREPARATION Before you start: 1.Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product 2.Take care when li�ing. Product should be assembled as near as possible to the point of 3.Ensure that you have all required contents for complete assembly 4.Always read the assembly instruc�ons carefully before beginning assembly.
Page 4
PARTS LIST ITEM QTY NO. ITEM 14PCS 4PCS Φ6*28 Φ4*35 4PCS 14PCS Φ12*10 20PCS Φ6*30 12PCS Φ3.5*12 ITEM QTY NO. ITEM 1 PC 1 PC LEFT SIDE PANEL BACK PANEL 1 PC RIGHT SIDE PANEL 1 PC DRAWER BACK PANEL 2 PCE SUPPORT PANEL 1 PC...
Page 9
STEP 9: ) M(L M(R) STEP 10: WARNING: IT IS STRONGLY RECOMMENDED THAT YOU ANCHOR THIS PRODUCT TO A WALL. YOUNG CHILDREN MAY BE INJURED OR KILLED BY TIPPING FURNITURE OVER. ALWAYS USE AN ANTI TOPPLE RESTRAINT. This hardware, when properly installed, could provide protection against the unexpected tipping of furniture due to improper use. Please ensure the anti-tipping hardware provided is suitable for your wall or else it might damage your wall during installation.
Page 12
SAFETY BRACKETS INSTRUCTIONS 1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to attach the Mounting Plate into a stud. If mounting into brick or masonry you will need to acquire wall anchors. 2. Attach the second Mounting Plate to the furniture frame with the Short Screws.
Page 13
To protect your furniture, we suggest the following: • Avoid placing your furniture in direct sunlight. • Do not place furniture directly under windows. • Do not place sharp materials (knife, fork, etc.) directly onto your furniture as sharp material may scrape and damage the finish.
Need help?
Do you have a question about the SMITHERS 69423 and is the answer not in the manual?
Questions and answers