Page 1
ASSEMBLY INSTRUCTION SMITHERS 6 Drawer Dresser ITEM CODE 69430 Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia. For any assistance with assembly or for missing parts please refer to your receipt...
PRE-ASSEMBLY PREPARATION Before you start: 1.Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product 2.Take care when li�ing. Product should be assembled as near as possible to the point of 3.Ensure that you have all required contents for complete assembly 4.Always read the assembly instruc�ons carefully before beginning assembly.
Page 4
PARTS LIST ITEM QTY NO. ITEM 44PCS 32PCS Φ6*28 Φ4*35 16PCS 46PCS Φ12*10 Φ3*12 33PCS 2PCS Φ6*30 Φ6*50 63PCS 2PCS Φ3.5*12 2PCS 6PCS 6PCS 6PCS 9PCS Φ4*12 ITEM QTY NO. ITEM 1 PC 1 PC LEFT SIDE PANEL BACK PANEL 1 PC RIGHT SIDE PANEL TOP PANEL...
Page 5
STEP 1: ( R ) ( R ) ( R ) ( L ) ( L ) ( L) STEP 2: ( L ) ( R ) ( R ) ( L ) ( L ) ( R ) ( R ) ( L )
Page 10
STEP 11: STEP 12: WARNING: IT IS STRONGLY RECOMMENDED THAT YOU ANCHOR THIS PRODUCT TO A WALL. YOUNG CHILDREN MAY BE INJURED OR KILLED BY TIPPING FURNITURE OVER. ALWAYS USE AN ANTI TOPPLE RESTRAINT. This hardware, when properly installed, could provide protection against the unexpected tipping of furniture due to improper use. Please ensure the anti-tipping hardware provided is suitable for your wall or else it might damage your wall during installation.
Page 11
STEP 13: ( L ) ( R ) ( L ) ( R ) STEP 14:...
Page 14
SAFETY BRACKETS INSTRUCTIONS 1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to attach the Mounting Plate into a stud. If mounting into brick or masonry you will need to acquire wall anchors. 2. Attach the second Mounting Plate to the furniture frame with the Short Screws.
Page 15
To protect your furniture, we suggest the following: • Avoid placing your furniture in direct sunlight. • Do not place furniture directly under windows. • Do not place sharp materials (knife, fork, etc.) directly onto your furniture as sharp material may scrape and damage the finish.
Need help?
Do you have a question about the SMITHERS 69430 and is the answer not in the manual?
Questions and answers