Intermec EasyCoder PL4 Quick Start Manual page 15

3 Pull the media supports apart, insert the roll of media
between them, and let the media supports close. Make sure
the media pulls off the core in the direction shown in the next
illustration.
Media
supports
The supports adjust themselves to the width of the media.
The media should be able to spin freely on the supports.
4 If you want to use the printer in Tear-Off mode, continue
with Step 6.
If you want to use the printer in Self-Strip mode, peel one or
two labels off of the backing material.
5 Close the media cover.
6 If you want to use the printer in Tear-Off mode, flip the
self-strip bar down away from the latch assembly.
If you want to use the printer in Self-Strip mode, slide the
self-strip bar up with your thumbs until it locks into place on
the latch assembly.
EasyCoder PL4 Printer Quick Start Guide
PL4Q013.eps
15