Maintenance; Warranty - Klein Tools IR1KIT Instruction Manual

ENGLISH

MAINTENANCE

BATTERY REPLACEMENT
When indicator is displayed on LCD, battery must be replaced.
1. Loosen the screw in the Battery Compartment Door
2. Remove exhausted 9V battery and dispose of appropriately.
3. Replace 9V battery and return Battery Compartment Door
and tighten screw to secure, taking care not to over-tighten.
Be sure meter is turned off and wipe with a clean, dry lint-free
cloth. Do not use abrasive cleaners or solvents. Take care
to keep the sensor lens clean at all times. If required, loose
debris may be removed from lens using clean compressed air.
Lens may also be cleaned using a soft cloth or cotton swab
with water or rubbing alcohol only . Lens must be allowed to
completely dry prior to use.
Remove the battery when meter is not in use for a prolonged
period of time. Do not expose to high temperatures or
humidity. After a period of storage in extreme conditions
exceeding the limits mentioned in the General Specifications
section, allow the meter to return to normal operating
conditions before using.
FCC & IC COMPLIANCE
See this product's page at www.kleintools.com for FCC
compliance information
Canada ICES-003 (B) / NMB-003 (B)

WARRANTY

www.kleintools.com/warranty
DISPOSAL / RECYCLE
Do not place equipment and its accessories in the trash.
Items must be properly disposed of in accordance with local
regulations. Please see www.epa.gov/recycle for additional
information.
CUSTOMER SERVICE
KLEIN TOOLS, INC.
450 Bond Street Lincolnshire, IL 60069 1-800-553-4676
6
customerservice@kleintools.com
3
CLEANING
STORAGE
www.kleintools.com
Relative Humidity: < 85% non-condensing
Operating Temperature: 32° to 140°F (0° to 40°C)
Storage Temperature: 14° to 122°F (-10°C to 50°C)
to open.
Operating Altitude: Up to 6562 ft. (2000 m)
Weight: 1.2 oz. (33 g)
Nominal Voltage: 110 - 125V AC at 50/60Hz in 3-wire outlet
3
Mains Supply Voltage Fluctuations: ±10%
Pollution Degree: 2
Nominal Power: 0.3W
Standards:
Conforms To UL Std 61010-1, 61010-2-030,1436
Certified To CSA Std C22.2 #61010-1, 61010-2-030,160
5001748
Drop Protection: 6.6 ft. (2 m)
Safety Rating: CAT II 300V
To ensure safe operation and service of the tester, follow these
instructions. Failure to observe these warnings can result in severe
injury or death. Retain these instructions for future reference.
• Failure to follow instructions could result in death or serious injury.
• Before each use, verify tester operation by testing on a known live and
correctly wired receptacle.
• Do not use if the tester appears damaged in any way.
• The tester is intended for indoor use only.
• Other equipment or devices attached to the circuit being tested could
interfere with the tester, clear the circuit before testing.
• This tester only detects common wiring problems.
• Always consult a qualified electrician to resolve wiring problems.
FIG. 2
INDICATOR
Neutral (White)
GENERAL SPECIFICATIONS - RT210
WARNINGS
Indicator
Illuminated
FAULT
Open Ground Ground contact is not connected
Open Neutral Neutral contact is not connected
Open Hot Hot contact is not connected
Hot/Ground Reversed Hot and ground connections are reversed
Hot/Neutral Reversed Hot and neutral connections are reversed
Correct Receptacle is wired correctly
Indicator
Not Illuminated
EXPLANATION
Hot (Black)
Ground (Green)
7