Intermec EasyCoder 401 User Manual page 8

Intermec EasyCoder 401 Linerless – User's Manual
PAPER LOAD, cont'd. EasyCoder 401 LLT
7
6
Pull out the paper and thread it under the slack absorber
and through the print unit as illustrated. Then push the Push the paper inwards as far as it will go in the print
roll inwards as far as it will go. unit. Make sure that it runs under the label stop sensor.
8 9
This diagram shows the label web path. Turn the printhead lift knob to "Print" position.
10 11
2.
1.
Release the slack absorber (1). Adjust the green guide
ring so the paper is guided with a minimum of play (2). Close the front and side doors.
7