Intermec EasyCoder 401 User Manual page 11

Intermec EasyCoder 401 Linerless – User's Manual
PAPER LOAD, cont'd.
6
Pull out the paper and thread it under the slack absorber
and through the print unit as illustrated. Then push the
roll inwards as far as it will go.
8
Thread the paper through the cutter so the equivalent of
at least one label protrudes outside the cutter.
10
Turn the printhead lift knob to "Print" position.
EasyCoder 401 LLC
7
Push the paper inwards as far as it will go in the print
unit. Make sure that it runs under the label stop sensor.
9
This diagram shows the label web path.
11
1.
Release the slack absorber (1). Adjust the green guide
ring so the paper is guided with a minimum of play (2).
2.
10