fantastic furniture Torkay Manual page 12

Step 13
You will need:
8 x Cam Nuts
Screws (H4)
(H2)
This is how a cam nut works........
The head of the cam
bolt goes into the open
mouth of the cam nut.
You then turn the cam
nut so it tightens over
the bolt.
Place the Top Panel (P1) onto the unit as shown.
Using the Phillips Head Screwdriver, insert 8x Cam Nuts (H2) into the Left and
Right Side Panels (P2 & P3) and Centre Panel (P5) as shown, ensuring the arrows
point towards the incoming Cam Bolts. Tighten the Cam Nuts (H2) to secure.
Attach the Top Panel Rail (P4) to the Top Panel (P1) using 4x Large Screws (H4),
tightening with the Phillips Head Screwdriver.
Step 14
You will need:
Phillips Head
4 x Back Panel
Screws (H5)
Using the pre-drilled holes on the Centre Shelf (P6) as a guide, secure the Back
Panels (P9x2) to the back of the unit with 4x Back Panel Screws (H5), tightening
with the Phillips Head Screwdriver.
fantasticfurniture.com.au
4 x Large
Phillips Head
Screwdriver
Screwdriver
(P1)
(H2)x8
(P2)
(P9)
(P9)
(H5)x4
(P4)
(P3)
(P9)
(H5)
(P9)
Page 12