Summary of Contents for fantastic furniture TOTO D4
Page 1
FURNITURE Version 1.0 TOTO Table D4 www.fantasticfurniture.com.au...
Page 2
WARNING : For safety any straps used to secure hardware or furniture parts must be removed before this product is used. Enjoy Your purchase from Australia’s Best Value furniture FURNITURE www.fantasticfurniture.com.au PAGE 2...
Page 3
Assembly checklist Read through the instructions carefully Make sure you have all the required tools. before you begin. Never use power tools unless instructed. Unless instructed, do not fully tighten Identify and lay out all the components screws until the item is fully assembled. before you begin assembly.
What you need to assemble the product Table Leg Table Leg Table Leg (P2) (P2) (P2) DO NOT USE Table Leg (P2) Table Top W/Apron (P1) Parts list Table Top (P1); Table Leg (P2); Hardware Pack. 8 x Bolts 8 x Flat Washer 1 x Allen Key 8 x Spring Washer (H2)
Page 5
Step 1 You will need 8 x Bolts 1 x Allen Key (H2) (H1) Spring Washer Flat Washer (H3) (H4) (P2) (P2) (P2) (P2) (P1) Attach table legs to table apron using Bolts (H2) and Washers (H3) & (H4). Note : Do not tighten bolts until table is on flat surface.
Assembly checklist Read through the instructions carefully Make sure you have all the required tools. before you begin. Never use power tools unless instructed. Unless instructed, do not fully tighten screws Identify and lay out all of the components until the item is fully assembled. before you begin assembly.
Page 10
What you need to assemble the product Seat Pad Other tools you need (P2) Seat (P1) Parts list Box 1: Seat (P1) x 1; Base Plate (P3) Seat Pad (P2) x 1 Base plate (P3) x 1 Legs (P4) x 4 Legs (P4) 12 x Bolts...
Page 11
Step 1 Allen Key Seat Pad Bolt (H5) (P2) (H1) You will need 2 x Bolts 1 x Allen Key M6x20mm (H5) (H1) Seat Seat (P1) (P1) Align and guide Seat Pad (P2) onto Seat (P1). Holding the Seat Pad (P2) in place, turn Seat (P1) over. Fasten Seat Pad (P2) onto Seat (P1) with 2 x Bolts (H1) through holes on Seat (P1) as shown.
Page 12
Step 3 You will need (P4) (P4) Bolt 1 x Allen Key 12 x Bolts (H3) Bolt M6x8mm (P4) (H3) (H4) (H3) Base Plate Bolt (P3) (H3) Attach 4 x Legs (P4) to Base Plate (P3) as shown with 12x Bolts (H3). Fully tighten all bolts using Allen Key (H4).