Hardware Contents; Warnings And Cautions - Procom FIB100 Manual

HARDWARE CONTENTS

Part Description
M4.2X8 Screw
AA
Cable Tie
BB
M4.0X8 Screw
CC

WARNINGS AND CAUTIONS

WARNING
• Read all instructions and warnings carefully before starting installation. Failure to follow these
instructions may result in a possible electric shock, fire hazard and will void the warranty.
• Read all instructions before using this appliance.
• If possible always unplug this appliance when not in use.
• Do not operate any heater with a damaged cord or plug or after the appliance malfunctions,
has been dropped or damaged in any manner.
• Any repairs to this appliance should be carried out by a qualified service person.
• Under no circumstances should this appliance be modified. Parts having to be removed for
servicing must be replaced prior to operating this appliance again.
• Do not use outdoors.
• Never locate this appliance where it may fall into a bathtub or other water container.
• Do not run cord under carpeting. Do not cover cord with throw rugs, runners or the like.
Arrange cord away from traffic areas and where it will not be tripped over.
• To disconnect this appliance, turn controls to the off position, then remove plug from outlet.
• Connect to properly grounded outlets only.
• This appliance, when installed must be electrically grounded in accordance with local codes,
with the current CSA C22.1 Canadian Electrical codes or for USA installations, follow local
codes and the National Electric Code, ANSI/NFPA No. 70.
• Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may
cause an electric shock, fire or damage the appliance.
• To prevent possible fire, do not block air intakes or exhaust in any manner.
• Use this appliance only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock or injury to persons.
• Avoid the use of an extension cord because of the risk of overheating the cord and the risk
of fire. Extension cords are for temporary use only. If an extension cord must be used, it
must be UL/CSA certified, rated at 10A (1250W), 125V maximum with 16 AWG minimum and
constructed of two current carrying conductors with ground. A heavy duty extension cord with
the shortest length possible for the connection is recommended and must not be longer than
50 ft. (15.2 m). Do not coil or cover the extension cord.
Quantity
6
6
1
Picture
(Shown to size)
3
Not shown to size